After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is configured with channel-group 1 mode active, while Switch B is configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working? A. The switches are using mismatched EtherChannel negotiation modes. B. The switch ports are not configured in trunking mode. C. LACP priority must be configured on both switches. D. The channel group identifier must be different for Switch A and Switch B.
Of course, Cisco 200-125 dumps are not intended for people who didn't study CCNA 200-125 at all.
According to Cisco best practices, which three protocols should the default ACL allow on an access port to enable wired BYOD devices to supply valid credentials and connect to the network? (Choose three.) A. BOOTP B. TFTP C. DNS D. MAB E. HTTP F. 802.1x
We are providing the helping material in two ways which are • PDF • Practice Test Software PDF Exam - the first technique expected of applicants to prepare for CCNA Routing and Switching 200-125 Cisco Certified Network Associate, are hand notes that consist of full, comprehensive information about every CCNA Routing and Switching 200-125 Cisco Certified Network Associate area.
Which feature must be enabled to eliminate the broadcasting of all unknown traffic to switches that are not participating in the specific VLAN? A. VTP pruning B. port-security C. storm control D. bpdguard
A network engineer must improve bandwidth and resource utilization on the switches by stopping the inefficient flooding of frames on trunk ports where the frames are not needed. Which Cisco IOS feature can be used to achieve this task? A. VTP pruning B. access list C. switchport trunk allowed VLAN D. VLAN access-map
Twitter Satpol PP
satpol pp sukoharjo tertibkan pedagang yang tidak mau masuk pasar darurat